2018 - Lockout/Tagout/ Tryout - Safety Training Crossword

When implementing Lockout/Tagout/Tryout, ________ all affected employees in the work area.
Lockout/Tagout/Tryout involves the use of a specific lock or locks to _____ equipment from all energy sources.
Source of energy by oil or water pressure
Source of energy with air pressure
Lockout/Tagout/Tryout procedures are not completed until you have ______ that the machine or process will not start
_____ by themselves, may only be used when locks cannot be used and when the employer can demonstrate that a tagout system will provide full employee protection
Only _________ employees may perform lockout/tagout/tryout procedures
Each lockout device must have a tag attached to identify the _______ of the person that put the lockout device in place
Lockout/Tagout/Tryout is used to isolate hazardous energy sources and to prevent death or _____ to employees
The lockout/tagout/tryout regulations are federal laws that are enforced by _____
Lockout devices cannot be ______ by anyone other than the person that put the lockout device in place
What time period must all lockout/tagout/tryout procedures be inspected/audited
What kind of energy sources must be controlled using lockout/tagout/tryout procedures before work may be performed on a piece of equipment
The employer is responsible for making sure that all of its employees receive adequate _____ concerning the lockout program
Failing to follow lockout/tagout/tryout procedures is a violation of the companies Cardinal Safety Rules, besides death or injury, what else could a consequence be
Which hand should an electrical disconnect switch be tripped with
Parts of a machine that fall or drop when power is lost are affected by this type of potential energy
Rectifiers and capacitors can actually store this form of energy even after power has been disconnected from the machine
Turning flywheels, springs under compression, and cams are all forms of this type of energy
The lockout/tagout/tryout __________ give you the steps that you need to follow in order to safely isolate all hazardous energy sources before working on a machine
__________ allow more than one lock to be applied to an energy isolating device
What must be put back in place before locks/tags, etc can be removed from a machine ready to be put back into service
If you have any questions about the lockout/tagout/tryout procedures for your machine who should you talk to first
All "___________" employees must be notified before a machine is shut down and lockout/tagout/tryout procedures are performed