Drill Press Crossword

Turn-off the power and _______the table before you leave the machine.
A drill press can be used for _________.
The machine operator is the only person in the ________ zone unless permission is given otherwise.
You should always turn the power off before ______ the depth stop.
Place a piece of flat stock _______ the work to be drilled.
Run large bits at a _____ speed.
Feed the drill bit smoothly into the work piece. When the hole is deep, withdraw it _____ to clear the shavings.
Keep your fingers at least _____ inches away from the rotating tool.
The four common operations that can be performed on the drill press are: Drilling, _____, countersinking and boring.
The ______ key may never be left in the chuck.
The _____ gauge or stop controls how far the drill bit can move.
Round wood stock can be drilled by holding the work piece in a ___________.
Use good judgment when drilling. If the tool smokes, _____ the speed and the rate of feed.
When using the drill press for operational work, make sure the position of the hole is well _____.
A countersink hole enlarges the top of a drilled hole so a _____ screw can be driven in flush.
Make sure the drill bit is free to go through the _____ in the drill press table.
Hold a work piece by a _______ to ensure that the spindle in motion does not cause the work piece to rotate.
Fasten he drill pit _____ into the chuck.
Long hair should be _____ back.
The wood will _______ if the work piece does not have scrap wood underneath it.