IED Unit 7 Key Terms Crossword

A system of dimensioning which requires all numerals, figures, and notes to be aligned with the dimension lines
The tightest possible fit between two mating parts.
A private, non-profit organization that coordinates the development and use of a voluntary consensus standards in the United States
A view that is used to show features that are located on an inclined surface in true size and shape.
A circle with a single number connected to an assembly component with a leader line to refer to parts.
A tolerance in which variation is permitted in both directions from the specified dimension.
A section of an object broken away to reveal an interior feature for a sectional drawing.
Also known as point-to-point dimensioning where dimensions are established from one point to the next.
Limits the size of mating parts so that a clearance always results when mating parts are assembled.
A cylindrical recess around a hole, usually to receive a bolt head or nut
A conical-shaped recess around a hole, often used to receive a tapered screw.
A line drawn on a view where a cut was made in order to define the location of the imaginary section plane
A dimensioning system where each dimension originates from a common surface, plane, or axis. Also known as baseline dimensioning.
A view that is used to show a magnified view of features that are too small to adequately specify in another view.
An inside radius between two intersecting planes
A sectional drawing based on a cutting plane line that cuts through one-quarter of an object. A half section reveals half of the interior and half of the exterior
This is a worldwide organization that creates engineering standards.
The largest and smallest possible boundaries to which a feature may be made as related to the tolerance of the dimension.
A drawing that contains all the information for making one part of the design.
A list of materials or parts specified for a project. Also referred to as a bill of materials or BOM
An outside radius applied to corners.
Thin lines used in a section view to indicate where the cutting plane line has cut through material.
A view that is used to show details not apparent on the exterior of the part.
The acceptable amount of dimensional variation that will still allow an object to function correctly..
A tolerance in which variation is permitted in only one direction from the specified dimension.